And by having access to our ebooks online or by storing it on your computer, you have convenient answers with Nec Phone System User Guide Pdf.

Our library is the biggest of these that have literally hundreds of thousands of different products represented.

They allow you to use the 8 VOIP ports that come with the system to connect IP phones like the IP7WW-8IPLD-C1 shown below.

Im going to assume you have the videos published by NEC for setting up a new system into a default state, then accessing it with PC Pro and setting up an initial IP address on your network.

Also assumed are a preexisting network with a DHCP server on the subnet you will be using.

Under Quick Install, CPU Settings, CPU IP address set to 0.0.0.0 (it will be replaced by the VOIP card).

Configure default gateway and subnet mask to what suits your network.

Following the above example I put the DSP IP as 192.168.1.147.

I left the RTP port at the default 10020.

Make sure to upload all changes then reset the system for the changes to take effect.

So this method utilizes the Plug and Play steps NEC outlines.

When the phone comes online after programming it will grab an open IP extension and just work.

From there press the following button sequence, HOLD Transfer.

Press the down arrow to move to the Password field and input 6633222 and then press the Okay softkey.

Press the down arrow on the next screen to go to SIP Settings and press the circular enter button above the down button to enter the page.

Press the down arrow again and then enter on Server Address URI.

Finally we reach pay dirt This is where we put in the IP we entered for the VIOP IP, which in my example is 192.168.1.146.

Enter into 1st Server Port and make sure you have 5080 in this field, unless for some reason you changed it in form 10-16-59.

You can have up to 8 SIP phones programmed like this without purchasing an actual VOIP daughter board and additional IP licenses.

Nec Phone System Programming